You can connect your new terminal to your POS by following the steps below.
1. From the terminal, press the ‘Func’ key, enter 11112227 into the terminal and press the ‘ENTER’ key.
2. The terminal will prompt ‘Configure Terminal Comms?’. Press the ‘ENTER’ key.
3. Select POS Comms Method as ‘Serial’ and press the ‘ENTER’ key.
4. Select Serial Port from either of the following:
• USB SLAVE - If using the USB cable on the base to connect to POS, as shown in the picture on
page 5. Then press the ‘ENTER’ key.
• COM0 - If using the Serial/RS232 cable to connect to POS, as shown in the picture on page 5.
Then press the ‘ENTER’ key.
5. Select Protocol as ‘VLI 115200’ and press the ‘ENTER’ key.